Operator Information Panel - IBM IntelliStation M Pro Hardware Maintenance Manual

5. Push the two of the four tabs on the right of the chassis toward the rear, and
6. Pull the fan up and out of the chassis.
To install the rear fan, reverse the previous steps.

Operator information panel

Before you begin:
v Read "Safety information" on page 129.
v Read "Installation guidelines" on page 31.
v Review the information in "System reliability considerations" on page 31.
Complete the following steps to remove the operator information panel:
1. Turn off the computer and attached devices; then, disconnect all external cables
2. Remove the cover and the frame-support bracket (see "Removing the cover" on
3. Swing the CD-ROM drive cage up.
4. Disengage the operator information panel cable from the system board.
5. Press upward on the lower tab of the operator information panel until it comes
6. Push inward on the two tabs of the top section of the operator information panel
To install the operator information panel, reverse the previous steps.
78
IBM IntelliStation M Pro Types 6220 and 6230: Hardware Maintenance Manual
then push in until the fan is released. Pull the fan out of the computer.
and power cords.
page 34 and "Removing and installing the support bracket" on page 35).
loose.
Note: It might be necessary to use the tip of a screwdriver to disengage the
lower tab.
Release
latch
Retainer slots
until it pops free of the chassis; then, remove it from the computer, making sure
that the cable follows freely.