Configuration File Selection - IBM 265 Service Manual

Configuration File Selection

Use the following steps to select a configuration file:
1. Is your modem an IBM 7852-400?
If Yes, use modem configuration file modem_m0.cfg and go to step 7 on page 315.
Note: The IBM 7852-400 modem has DIP switches on the right side of the unit.
If No, continue with step 2.
2. Is your modem an IBM 7857-017?
If Yes, use modem configuration file modem_m1.cfg and go to step 7 on page 315.
Note: The IBM 7857-017 modem has two telephone line connections on the back
If No, continue with step 3.
3. Does your modem respond to the extended command set (prefixed with &)?
If Yes, go to step 5.
If No, continue with step 4.
4. Does your modem respond to:
v ATZ reset command
v ATZ n reset commands, where n can be 0, 1, and so on?
Go to step 7 on page 315.
5. Does your modem command set include a test for V.42 error correction at the
remote modem (often called "Auto-Reliable Mode")?
If Yes, disable this test. You can use sample configuration files
/usr/share/modem_m0.cfg or /usr/share/modem_m1.cfg as models to help you
create a file for your particular modem. See "Customizing the Modem Configuration
Files" on page 316 for more information. Go to step 7 on page 315.
If No, go to step 6.
6. Does your modem respond to:
v AT&F reset command
v AT&F n reset commands, where n can be 0, 1, and so on?
314
Service Guide
See "IBM 7852-400 DIP Switch Settings" on page 317 for the correct switch
settings.
of the unit. One is marked LL (for Leased Line), and the other is marked
PTSN (for Public Telephone Switched Network). The service processor
expects to use the modem on the public network, so the telephone line
should attach to the PTSN connector.
or
If ATZ, configuration file modem_z.cfg is recommended.
If ATZ n , configuration file modem_z0.cfg is recommended.
or