IBM 265 Service Manual page 132

Table 3. Firmware Error Codes. (continued)
Error Code Description
25010007 Image has bad CRC.
25010008 Flash is write-protected, update
25010009 Flash module is unsupported or not
2501000A Flash write-protected.
2501000C Failed write to flash memory
25A0xxx0 L2 cache controller problem.
116
Service Guide
cancelled.
recognized.
Action / Possible Failing FRU
1. Power-on the system unit.
2. Do the following flash recovery
procedure:
a. Insert a newly formatted DOS
diskette loaded with service
processor firmware into the
diskette drive. The file name
must be spflash.img .
b. Shut down the system unit and
unplug the power cable.
c. Plug in the power cable,
power-on the system unit.
3. Retry item 2 with a newly
formatted DOS diskette.
4. Go to "MAP 1540: Minimum
Configuration" on page 59.
1. Turn off, turn on system unit and
retry.
2. Replace the system board.
Location: P1
(See notes on page 109.)
Make sure correct firmware update
diskette is being used with this
system.
1. Turn off, turn on system unit, retry.
2. Replace the system board.
Location: P1
(See notes on page 109.)
1. Turn off, turn on system unit, retry.
2. Replace the system board.
Location: P1
(See notes on page 109.)
1. Replace the processor card.
Location: P1-C1
Location: P1-C2
Replace the system board.
Location: P1
(See notes on page 109.)
See error code 2B2xxx22 for xxx
definitions.