Table of Contents
Advertisement
Figure 2 shows the rear panel of IP71.
Figure 2 IP71 Rear View
Ethernet WAN
Restoring Factory Defaults
Restore Defaults button is inside a hole on the back panel of the IP71. To
press the button, use a straightened paper clip or pin. Pressing the Restore
Defaults button restores all IP71 settings back to factory defaults. The button
works only after booting is complete, and the green light must be illuminated
to activate the button. The status light goes off while defaults are being
restored, and re-lights after defaults are restored and the IP71 begins to
reboot. It takes over 2 minutes to restore defaults. After the defaults are
restored and the IP71 has rebooted, you will be able to connect only through
the console.
Before You Begin
For simplicity, this guide assumes you are using a DSL ISP account. The IP71
also works with any Internet access device that supports an Ethernet interface,
such as routers that use analog, cable, ISDN, or T1 lines.
To set up the IP71 to connect to the Internet, you need
n
n
n
n
Nokia IP71 User Guide
Ether net WAN
An installed line (DSL or T1) with an ISP account
An IP address and a Net Mask address for your IP71
An Internet access device such as an analog, cable or ISDN DSL modem/
router or T1 router with an Ethernet port for the LAN
A Check Point NG SMB certificate key to obtain the NG license
Console
4
Ethernet LAN
Console
Restoring Factory Defaults
DC 12V
2
3
1
Restore Defaults
15
Advertisement
Table of Contents
