Ack Character; Nak Character - Datalogic Gryphon I GFS4400 Product Reference Manual

RS-232/USB-Com Interfaces

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
7 Data Bits.

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
7 Data Bits.
Product Reference Guide
$CR2AC
Select ACK Character Setting
DEFAULT
$CR2NA
Select NAK Character Setting
DEFAULT
0x06 'ACK' Character
See
0x15 'NAK' Character
Enter/Exit Programming Mode
page 246 for more information.
Data Bits
has been set as
page 247 for more information.
Data Bits
has been set as
33