Datalogic Gryphon I GFS4400 Product Reference Manual page 262

References
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suf-
3. Scan a bar code to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 6. Label ID Position Options
260
and scan the ENTER/EXIT bar code.
page 57
fix) by scanning the appropriate bar code in the section
ence for Label ID positioning options if multiple identification features are
Figure 6
enabled.
ID from the section
"Label ID Symbology Selection − 1D Symbologies" on page 58
Label ID for the selected symbology.
on the inside back cover of this manual and find the equivalent hex
ASCII Chart
digits associated with your choice of Label ID. For example, if you wish to select an equal
sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 305
mined. For the example given, the characters '3' and 'D' would be scanned. More exam-
ples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Prefix Label ID
and scan the bar codes representing the hex characters deter-
.
Table 34
Aim ID Bar Code Data
OR
Data Editing
"Label ID Control" on page 57
.
Label ID Suffix
Gryphon™ I GFS4400
. Refer-