Datalogic Gryphon I GFS4400 Product Reference Manual page 24

Enter/Exit Programming Mode
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each pro-
2. Scan the bar code to set the desired programming feature. You may need to cover unused
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
For more detailed descriptions, programming information and examples for setting selected
configuration items, see
22
You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to
complete the appropriate procedure.
gramming page, when applicable.
bar codes on the page, and possibly the facing page, to ensure that the reader reads only
the bar code you intend to scan.
priate characters from the keypad.
Additional information about many features can be found in the "Refer-
ences" chapter.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
MING bar code to exit Programming Mode.
References, starting on page
Setup, starting on page 13
Appendix E, Keypad, and scan the appro-
243.
Gryphon™ I GFS4400
and