References
USB Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =
3. Go to
4. Scan the bar code: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 32. USB Intercode Delay Examples
STEP
ACTION
1
Desired Setting
2
Pad with leading zero(es)
3
4
Scan Two Characters From
5
Appendix E, Keypad
6
252
20, etc
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter
page 43
Programming Mode.
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
No Delay
00
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCODE DELAY SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix E, Keypad
for some examples of how to set this feature.
Table 32
EXAMPLES
5 Seconds
60 Seconds
05
'0' and '5'
RS-232 Parameters
, that represent the
99 Seconds
60
99
'6' and '0'
'9' AND '9'
Gryphon™ I GFS4400