Error Codes - Datalogic Gryphon I GFS4400 Product Reference Manual

Programming Mode
Mode
Indicator
Label Programming
Mode Entry
Label Programming
Mode Rejection of
Label
Label Programming
Mode Acceptance of
Partial Label
Label Programming
Mode Acceptance of
Programming
Label Programming
Mode Cancel Item
Entry

Error Codes

Upon startup, if the reader sounds a long tone, this means the reader has not passed its automatic
Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is reset, the
sequence will be repeated. Press and release the trigger to hear the FRU indication code.
The following table describes the LED flashes/beep codes associated with an error found.
Number of LED Flashes/
Product Reference Guide
The following indications ONLY occur when the reader is in Programming
-
.
A valid programming label
has been scanned.
A label has been rejected.
In cases where multiple
labels must be scanned to
program one feature, this
indication acknowledges
each portion as it is suc-
cessfully scanned.
Configuration option(s)
have been successfully pro-
grammed via labels and the
reader has exited Program-
ming Mode.
Cancel label has been
scanned.
Beeps
1
2
6
11
Description
LED blinks continu-
Error
Configuration
Interface PCB
Digital PCB
Imager
Technical Specifications
LED Beeper
Reader sounds four
low frequency beeps.
ously
Reader sounds three
times at lowest fre-
N/A
quency and current
volume.
Reader sounds one
short beep at highest
N/A
frequency and cur-
rent volume.
Reader sounds one
high frequency beep
N/A and 4 low frequency
beeps followed by
reset beeps.
Reader sounds two
times at low fre-
N/A
quency and current
volume.
Corrective Action
Contact Helpdesk
for assistance
283