Good Read Led Duration - Datalogic Gryphon I GFS4400 Product Reference Manual

Reading Parameters

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 100 milliseconds to 25,500
milliseconds (0.1 to 25.5 seconds) in 100ms increments. A setting of 00 keeps the LED on until
the next trigger push.
See page 267
$CLAGL
Select Good Read LED Duration Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
in "References" for detailed instructions and examples for setting this feature.
DEFAULT
Enter/Exit Programming Mode
$CLAGL00(CR)
Good Read LED Duration Setting =
Keep LED on until next trigger push
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix E, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
~
CANCEL
003 = Good Read LED
stays on for 300 ms.
79