Deactivation Event; Deactivation Timeout - Datalogic Gryphon I GFS4400 Product Reference Manual

Digital Output

Deactivation Event

Defines the event deactivating the output. See
"References" for more information about this feature.
$COUD100\r
$COUD102\r
Reading Phase Active

Deactivation Timeout

When Timeout is the selected Deactivation Event, this specifies the maximum duration of the
output pulse.
$COUT1
Set Deactivation Timeout
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
Product Reference Guide
Disable
DEFAULT
"Wrong Code String" on page 264
DEFAULT
$COUD101\r
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE barcode above, then the barcode at left fol-
lowed by the digits (in hex) from the Alphanumeric
characters in Appendix E, Keypad
desired character(s). Exit programming mode by scanning
the ENTER/EXIT barcode again.
~
005 = 500 msec
Enter/Exit Programming Mode
in
Timeout
representing your
CANCEL
71