Central Code Only; Illumination Off Time - Datalogic Gryphon I GFS4400 Product Reference Manual

Enter/Exit Programming Mode

Central Code Only

Specifies the ability of the reader to decode labels only when they are close to the center of the
aiming pattern. This allows the reader to accurately target labels when they are placed close
together, such as on a pick sheet.
See Appendix B, Aimer Calibration
aiming coordinates.
$CSNPM01(CR)
Central Code Only = Enable

Illumination Off Time

This feature defines the amount of time illumination is kept OFF after Illumination ON
timeout. When illumination OFF expires, Object Sense is resumed. This configuration is
available in Automatic (Object Sense) only. Range is 0 millisecond to 25.5 milliseconds in 100
millisecond intervals.
$CSNOO
Select Presentation Mode Time Setting
84
This feature is not compatible with Multiple Labels Reading in a Volume.
DEFAULT
DEFAULT
starting on page 285 for information about setting the
$CSNPM00(CR)
Central Code Only = Disable
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
representing your desired charac-
Appendix E, Keypad
ter(s). End by scanning the ENTER/EXIT bar code again.
0 milliseconds
Reading Parameters
Gryphon™ I GFS4400