Datalogic Gryphon I GFS4400 Product Reference Manual page 263

Data Editing
Table 34
STEP ACTION
1. Scan the ENTER/EXIT bar code
Determine placement of the
Label ID characters BEFORE or
AFTER with regard to scanned
2.
data using
Control, starting on page 57
Scan the bar code selecting
the symbology type you wish
to designate label ID
3.
characters for using
Symbology Selection − 1D
Symbologies, starting on page 58
Custom Label ID example
4.
(desired characters):
Find hex equivalents from the
(inside back cover),
ASCII Chart
then scan in these digits/
characters using the bar codes
in the section:
5.
. If you make a
on page 305
mistake before the last
character, scan the CANCEL
bar code to abort and not save
the entry string. You can then
start again at the beginning.
6. Scan the ENTER/EXIT bar code
Scan the ENTER/EXIT bar code
7.
once again
Result:
Product Reference Guide
. Label ID Examples
Enable as Prefix
Label ID
DataBar
Omnidirectional
Label ID
.
D B *
Keypad, starting
44 42 2A
DB*[bar code
data]
EXAMPLES
(Scanner enters Programming Mode)
Enable as Suffix Enable as Prefix
Code 39 Interleaved 2 of 5
= C 3 +
3D 43 33 2B
(Scanner exits Label ID entry)
(Scanner exits Programming Mode)
[bar code
+[bar code data]
data]=C3
References
Enable as Suffix
Code 32
P H
50 48
[bar code data]PH
261