Qos; Mode; Queue Schedule - netsys G.SHDSL.bis 3010E User Manual

4.4.4

QoS

QoS(Quality of Service) is to decide which PCs can get the priorities to pass though EFM modem once
if the bandwidth is exhausted or fully saturated.
Move the cursor " >> " to qos and press enter.
>> mode Trigger Quality of Service function
qSchdl Modify queue schedule type
qweight Modify queue weight
q0GrssRt Modify queue 0 egress rate
q1GrssRt Modify queue 1 egress rate
q2GrssRt Modify queue 2 egress rate
q3GrssRt Modify queue 3 egress rate
portPri Modify port priority
vlanTagPri Modify VLAN TAG priority
ipDscpPri Modify IP DSCP priority
list Show QoS configuration
4.4.4.1

Mode

User can choose three types of QoS: Port Based, VLAN Tag, IP DSCP. When you don't use QoS, set to
Disable.
-----------------------------------------------------------------------------
Command: setup qos mode <Disable|PortBased|VlanTag|IpDscp>
Message: Please input the following information.
Trigger qoS function (TAB Select) <Disable>:
-----------------------------------------------------------------------------
QoS Mode:
QoS Mode □Disable □Port Based
4.4.4.2

Queue schedule

There are three types queue schedule: Type 1 and Type 2 for your selection.
The schedule types according to following table:
Queue 0
Type 1 WRR
Type 2 BE
Type 3 BE
3010E/3020E/3040E G.SHDSL.bis EFM Bridge Modem User's Manual Ver:A2
□VLAN Tag
Queue 1 Queue 2 Queue 3
WRR WRR WRR
WFQ WFQ
WFQ WFQ
76
□IP DSCP
WFQ
SP