Table of Contents
Advertisement
4.4.1.8
The Clear command can clear CRC error count.
SHDSL.bis:
Mode
□STU-C
Link Type
□2-wire
Annex Type
□AF
TCPAM
□Auto □TCPAM-16 □TCPAM-32
Max Main Rate
(3~177)
SNR Margin
(-10~21)
Line Probe
□Disable □Enable
4.4.2
LAN
You can setup the LAN parameters by the command lan. Move the cursor " >> " to lan and press enter.
-----------------------------------------------------------------------------
Command: setup lan <1~1>
Message: Please input the following information.
Interface number <1~1>: 1
-----------------------------------------------------------------------------
The default interface number is 1.
LAN interface parameters can be configured Link type, LAN IP address and subnet mask.
Select link_type item:
>> link_type
Configure Link type
address
LAN address and subnet mask
-----------------------------------------------------------------------------
Command: setup lan 1 link_type <Disable|Dynamic|Static>
Message: Please input the following information.
Link type (TAB Select) <Disable>:
-----------------------------------------------------------------------------
You can select the lan 1 link type is Disable, Dynamic or Static.
Select address item:
link_type
Configure Link type
>> address
LAN address and subnet mask
-----------------------------------------------------------------------------
Command: setup lan 1 address <ip> <netmask>
Message: Please input the following information.
3010E/3020E/3040E G.SHDSL.bis EFM Bridge Modem User's Manual Ver:A2
Clear
□STU-R
□4-wire
□8-wire
□BG
71
Advertisement
Table of Contents
