Table of Contents
Advertisement
3.4.1
Operation mode and MGMT
Click Basic for basic installation.
Click CPE (Customer Premises Equipment) side or CO (Central Office) side to setup the operation
mode.
When connection with EFM DSLAM, the SHDSL.bis EFM modem's working mode is CPE. When "LAN to
LAN" connection, one side must be CO and the other side must be CPE.
Enter Parameters in MGMT item.
The EFM modem needs an IP address for it to be managed over the network. The factory default IP address
is 192.168.1.1. The subnet mask specifies the network number portion of an IP address. The factory default
subnet mask is 255.255.255.0 . You can configure another IP address in a different Subnet Mask for
management purposes.
IP: 192.168.1.1
Subnet Mask: 255.255.255.0
Host Name: SOHO
Some of the ISP requires the Host Name as identification. You may check with ISP to see if your Internet
service has been configured with a host name. In most cases, this field can be ignored.
And then, click Trigger DHCP service is Disable or Server. If you don't need the DHCP service, please click
Disable.
3010E/3020E/3040E G.SHDSL.bis EFM Bridge Modem User's Manual Ver:A2
21
Advertisement
Table of Contents
