Setup; Shdsl.bis; Mode; Link - netsys G.SHDSL.bis 3010E User Manual

4.4 Setup

All of the setup parameters are located in the subdirectories of setup. Move the cursor " >>" to setup and
press enter.
>> shdsl.bis Configure SHDSL.bis parameters
lan Configure LAN interface profile
vlan Configure virtual LAN parameters
qos Configure Quality of Service parameters
rate Configure Rate Limiting parameters
mgmt Configure management interface profile
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory default setting

4.4.1 SHDSL.bis

You can setup the SHDSL.bis parameters by the command shdsl.bis. Move the cursor " >> " to shdsl.bis and
press enter.
>> mode Configure shdsl.bis mode

link

Configure shdsl.bis link
annex Configure shdsl.bis annex type
tcpam Configure shdsl.bis TCPAM type
maxMainRate Configure shdsl.bis max main data rate
snrMagrin Configure Shdsl.bis SNR margin
lineProbe Configure shdsl.bis line probe
clear Clear current CRC error count

4.4.1.1 Mode

There are two types of SHDSL.bis mode, STU-C and STU-R. STU-C means the terminal of central office and
STU-R customer premise equipment.
4.4.1.2 Link
Line type means how many wire you want to use on SHDSL.bis connection. Link type will be 2-wire, 4-wire or
8-wire mode according to the product type. 4-wire product can be worked under 2-wire mode. 8-wire product
can be worked under 2-wire mode.
Link type
2-wire
EFM modem
2-wire model ●
3010E/3020E/3040E G.SHDSL.bis EFM Bridge Modem User's Manual Ver:A2
69