Port Based Vlan - netsys G.SHDSL.bis 3010E User Manual

packet form the port. The port index 1 to 4 represents LANs ports, index 5 represents DSL and index 6
represents Sniffing respectively.
-----------------------------------------------------------------------------
Command: setup vlan link_mode <1~6> <Access|Trunk>
Message: Please input the following information.
Port index <1~6>: 1
Port link type (TAB Select) <Access>:
-----------------------------------------------------------------------------
Access The port can receive or send untagged packets
Trunk The port can receive or send tagged packets
802.11Q VLAN:
1
No. VID LAN1 LAN2
1
2
3
4
5
6
7
8
PVID
□ □
Access Access
Link Type
□ □
Trunk Trunk
4.4.3.3
With port-based VLAN, the port is assigned to a specific VLAN independent of the user or system
attached to the port. This means all users attached to the port should be members in the same VLAN.
The port based setting performs the VLAN assignment. The port configuration is static and cannot be
automatically changed to another VLAN without manual reconfiguration.
For Port Based VLAN, user must set up the table using 802.11Q methods. But don't care the value of VID ,
PVID or link type.
3010E/3020E/3040E G.SHDSL.bis EFM Bridge Modem User's Manual Ver:A2
2 3 4
LAN3 LAN4
□ □
Access Access
□ □
Trunk Trunk

Port Based VLAN

74
5 6
DSL Sniffing
□ □
Access Access
□ □
Trunk Trunk