Table of Contents
Advertisement
3.5.2.1 Tag-Based VLAN
Click the Tag-Based VLAN to configure the EFM modem.
En:
Check if you want to apply this rule.
VID:
VLAN ID
MGMT:
Check if you want this rule to manage the modem.
Port:
port interfaces, including LAN1, LAN2, LAN3, LAN4, and DSL. Check the port interface you
need if you want to include the port.
Access:
Trunk:
Hybrid:
Tunnel:
S-VLAN Tunnel: this section is for "Tunnel" mode.
Mode:
TPID:
VID:
3010E/3020E/3040E G.SHDSL.bis EFM Bridge Modem User's Manual Ver:A2
allows all packets passing through the port interface
only these packets with assigned VLAN ID can pass through via the port interface.
if the incoming packet carries a VLAN ID, then, the EFM modem will check the
VLAN ID with the assigned PVID. If the packet includes no VLAN ID, then, the
EFM will not check.
if you would like to enable Q-in-Q mode or VLAN mapping feature, please choose
this access mode.
to choose either you want to run "Q-in-Q" or "VLAN mapping".
Tag Protocol Identifier, a 16-bit field set to a value of 0x8100 (the typical value) for
identifying the frame as an IEEE 802.1Q-tagged frame. Note: when you choose
"Mapping", you are not allowed to change this value.
VLAN ID.
29
Advertisement
Table of Contents
