System Event - Syscom Video Direct IP Operation Manual

Network camera

Hide thumbs Also See for Direct IP:

Table of Contents

Operation Manual

System Event

Check the System Event box to set up a system event. The camera checks and reports the system

status.

 System Alive: Check the box to check the system operation, and select the check interval.

− Send Email: Check the box to send an email when the system is operating.

− Remote Callback: Check the box and select the remote systems to send a message when

the system is operating (Not supported for the WebGuard program)

NOTE: You must properly configure the Email and Remote Callback settings when setting them

up to send an email or a message. Refer to the Event Action setup

Table of Contents

Do you have a question about the Direct IP and is the answer not in the manual?