Factory Reset; Mounting - Syscom Video Direct IP Operation Manual

Operation Manual
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.
MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY
FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET. USE
THE POWER CORD THAT HAS A GROUNDING PIN. IF YOUR POWER OUTLET
DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG.
DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES INTO ONE
CIRCUIT.

Factory Reset

This will only be used on the rare occasions that you want to return all the settings to the original
factory settings. Refer to the INIT User's Manual for details on remote factory resetting.
CAUTION: When performing a Factory Reset, you will lose any settings you have
saved.
8

Mounting

1. Screw the camera sun shield to the camera using
the screw and rubber provided with the camera.
2. Screw the mounting bracket to the wall or ceiling
by using screws provided with the camera.
3. Screw the bottom cover to the mounting bracket
by using screws provided with the camera.
4. Adjust the camera angle by bending the stand.
5. Connect external devices, network and power
adapter.
6. Apply power.
WARNING: You might need to reinforce
the wall or ceiling. If the wall or ceiling is
not strong enough to support the camera,
the camera might fall damaging the camera
or causing injuries.