Port/Qos - Syscom Video Direct IP Operation Manual

Operation Manual
NOTES:
 The FEN (For Easy Network) function allows the camera to use dynamic IP addresses for
remote connection. When using this function, you can access the camera remotely by
using the camera name instead of its IP address. For the FEN function to work properly,
the camera should be registered on the FEN server, and the FEN server settings in the INIT
program for the camera should match the settings registered on the FEN server. Any
changes on the FEN server might cause improper operation.
 When LAN settings are changed, set up the FEN settings after saving your LAN changes by
clicking the OK button.
 You will need to get the IP address or domain name of the FEN server from your network
administrator. You can use the domain name instead of IP address if you set up the DNS
server during the IP Address setup.
 When using a NAT (Network Address Translation) device, refer to the NAT manufacturer's
instructions for the proper network settings.
 The camera name you entered in the Camera Name field should be checked by clicking the
Check button, otherwise the FEN changes will not be saved. When entering no name or a
name already registered on the FEN server, an error message displays. If a camera name
includes the #, \, or % characters, connections to the camera using a WebGuard program
might fail.

Port/QoS

 Use, Port: Check the box to enable and enter the port number. Admin, Watch and Record
ports are set to use by default and you cannot change it. Checking the WebGuard or RTSP box
allows you to connect to the camera by using the WebGuard program or media players, such
as VLC Player, supporting RTSP (Real-Time Streaming Protocol) service. Remote Setup closes
after saving the changes (Admin port number only).
16