Illustrated Parts List; Cable Assembly - Syscom Video Direct IP Operation Manual

Operation Manual
 Optical
Lens: zoom lens is installed.
 IR LED: The sensor in the
are lit at night or under low lighting conditions.
middle of IR LEDs detects motions by detecting infrared radiation changes at night or under low
lighting conditions (alarm supported model only). The motion detection by the PIR sensor activates
alarm out according to the settings of Alarm Out (Remote Setup > Event Action > Alarm Out), and
the white LEDs which are at the left and right middle of IR LEDs are lit while the alarm out is activated.

Body: The cables are connected through the stand.

Stand: Allows you to adjust the camera angle and lens' rotation angle. Twist the setscrews
counterclockwise and move the camera to the desired direction. Once it is set, twist the setscrews
clockwise to lock it.
 Bottom Cover: Allows you to mount the camera to the wall or ceiling
provided with the camera

Mounting Bracket: Allows you to mount the camera to the wall or ceiling.

Cable Assembly: See below.

Sun Shield Screw Hole: Allows you to screw the sun shield to the camera.

Cable Assembly

6

Illustrated Parts List

middle of IR LEDs detects low illumination and the IR LEDs
bottom
.
① Lens
② IR LED
③ Body
④ Stand
⑤ Bottom Cover
⑥ Mounting
⑦ Cable Assembly
⑧
The PIR (Passive Infrared) sensor in the upper
① BNC Video Out (yellow cable)
② Power In (red cable)
③
Network Port
Bracket
Sun Shield
Screw Hole
using the mounting bracket