Streaming - Syscom Video Direct IP Operation Manual

Operation Manual

Streaming

 Primary, Secondary, Tertiary: The camera supports multistream video (priority: Primary >
Secondary > Tertiary). Set whether to enable or disable the streams. Some of the settings may
change depending on the settings of streams of higher priority and the tertiary stream may not
be available (see the table below).
Primary
Resolution
1920x1080
 Compression: Set up the compression of images for streaming.
 Resolution: Set the resolution of images for streaming. The resolution of the current stream
cannot exceed that of a stream of higher priority.
 Quality: Set up the quality of images for streaming.
 Bitrate Control: Set up the bitrate control mode for H.264 compression.
− CBR (Constant Bitrate): Maintains the current bitrate regardless of the amount of motion.
− VBR (Variable Bitrate): Adjusts the bitrate dynamically based on the amount of motion. The
less motion there is, the less network congestion and the less storage consumption. The quality
may not be as good when compared to the CBR mode
 Frame Rate: Set the frame rate of images for streaming. The frame rate of the current stream
cannot exceed that of a stream of higher priority if the resolution of the current stream is the same
as that of the stream of higher priority.
 Default Record Stream: Select a stream to use for recording. If a recording stream is set up
in a remote program, this setting may not be applied.
 Multi-View Streaming: It allows you to set up a streaming area to stream specific area of video
(not supported for the primary stream). Click the Setup button and set up the streaming area.
26
Secondary
ips Resolution
30 704x480
Tertiary
ips Resolution
30 –
.
ips
–