Shock Absorber Spring Preload Adjustment (Te-Tc-Txc) - Husqvarna TC 449 2011 I.E. Workshop Manual

SETTINGS AND ADJUSTMENTS
TC 449 2011/2012 I.E.
TE 449 - 511 2011/2012 I.E.
TXC 449 - 511 2011/2012 I.E.
SMR 449 2011 I.E.
SMR 511 2011/2012 I.E.
2
1
3
H11154
1
2
3
H006159

Shock absorber spring preload adjustment (TE-TC-TXC)

Proceed as follows:
1. Remove the saddle and right-hand side panel, as described in the relevant
paragraph.
2. Clean lock ring nut (1) and adjuster ring nut (2) of the spring (3).
3. Either with a hook wrench or an aluminium punch, loosen the lock ring nut.
4. Turn the adjuster ring nut as required.
5. Adjust preload to suit your weight or riding style and tighten the lock ring nut
firmly (tightening torque 10 Nm - 1 Kgm - 7.38 ft-lb).
6. Refit the right-hand side panel and the saddle.
Be careful not to touch hot exhaust pipe while adjusting the shock
absorber.
TE-TC-TXC MY11:
A = Spring standard length, when preloaded: 251 ± 0,5 mm (9,88 ± 0,02 in.)
B = Free length = 451,5 mm (17,78 in.)
Maximum length = 453 mm (17,83 in.)
Minimum length = 323 mm (12,72 in.)
TE MY12:
A = Spring standard length, when preloaded: 251 ± 0,5 mm (9,88 ± 0,02
in.)
B = Free length = 448,0 mm (17,64 in.)
Maximum length = 449,0 mm (17,68 in.)
Minimum length = 326,5 mm (12,85 in.)
TC-TXC MY12:
A = Spring standard length, when preloaded: 270 ± 0,5 mm (10,63 ± 0,02 in.)
B = Free length = 452,0 mm (17,8 in.)
Maximum length = 453,0 mm (17,83 in.)
Minimum length = 326,5 mm (12,85 in.)
D.21
Workshop Manual Ed. 03-2012