Outdoor Installation On A Wall, Pole Or Corner (With Accessories) - Mobotix D15 Manual

Overview of Mounting Options
Special Case: D15-180 Mounted to a Wall without the Wall Mount
The lens mount unit has to be rotated by 180° so that you do not get an upside down pan-
orama image. For further information, see the end of Section 2.3.1, «Mounting Lens Units» .
Make sure that the camera is always mounted on a smooth surface . Otherwise,
the sealing lip on the underside of the housing will not be able to close tightly or
will bend upwards, which leads to leaks between the outer shell and the housing.

2.1.2 Outdoor Installation on a Wall, Pole or Corner (with Accessories)

The associated Outdoor Wall Mount can be used to mount the D15 outdoors. The camera
is then compliant with the IP65 protection class (fully dustproof and resistant to water jets).
Ambient temperatures may vary between –30 to +60 °C/–22 to +140 °F, making it the
ideal camera for the most demanding weather situations. The drill holes must be prepared
for the installation. Use the supplied drilling template to mark the position of the holes for
the fixtures and the holes through which the cables will be led later on (fold-out).
If you would like to mount the MOBOTIX D15 to the corner of a building or to a pole, you should
consider using the MOBOTIX Corner And Pole Mount. This mount can only be used together
with the Outdoor Wall Mount. The supplied stainless steel straps allow the mount to be attached
to poles with diameters between 60 and 180 mm.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Note
43
/112
The folded drilling
templates can be found
at the end of the manual
When printing, make sure
that the drilling template
is printed in its original
size (is neither enlarged
nor reduced in size)
Make sure that the
arrows are pointing
upwards when mounting