Starting The Camera With The Factory Ip Address - Mobotix M15 User Manual

110
/148
Passwords and cam-
era settings will
not be changed
Use a paper clip for
this purpose but
avoid using sharp or
pointed objects!
Make sure you store the
factory default network
configuration to the
permanent flash memory
M15 Camera Manual: Operating The Camera

3.2.5 Starting the Camera with the Factory IP Address

Under certain circumstances, you may have to reset the camera to its factory IP address.
This could be the case, for example, if the IP address has been lost or the camera does
not respond to the last known IP address. Proceed as follows to start up the camera with
its factory IP address:
1. If the camera is powered on, disconnect the power supply by unplugging the cor-
responding cables and then reconnect the power supply.
2. Wait until both LEDs light up simultaneously for the first time.
3. Press the L key within the next four seconds and hold it down (if you need to
try again, go back to step 1).
R
4. Only release the L key once the camera emits a single sound ("boing").
If you use the camera's L key to load the factory default network configuration, this
configuration is not automatically saved in the camera's flash memory. When the
camera is next rebooted without using the L key, the last stored network configuration
will be used. To permanently store the new network configuration in the camera's
flash memory, open Admin Menu > Store.
The user information will not be reset if the camera is booted using the factory IP
address, in contrast to resetting the camera using Admin Menu > Reset configura-
tion to the factory settings.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Notes
www.mobotix.com • sales@mobotix.com
L