Important Notes; Mobotix M22M-Weatherproof With Ip65; Password For The Administration Menu; Irreversibly Deactivating The Microphone - Mobotix M22M Manual

14
/56
Administration menu:
User: admin
Password: meinsm
The microphone can be
deactivated irreversibly!
M22M Camera Manual Part 1

1.4 Important Notes

1.4.1 MOBOTIX M22M—Weatherproof with IP65
MOBOTIX M22M is IP65 weatherproof (absolutely dustproof, resistant against
water jets) when used with the MOBOTIX M14 lenses and mounted lens cover.
CAUTION: Only use the supplied connection cables and make sure
that the supplied rubber plugs have been fitted to seal off both
connectors. Note that the camera must never be installed without
properly installed connection cables and rubber plugs!

1.4.2 Password for the Administration Menu

The administration area of the camera (Admin Menu button) is protected by a user
name and password:
• User name is admin
• Password is meinsm
Enter the user name and password exactly as shown above. Note that both entries
are case-sensitive. When accessing the administration menu for the first time, the
Quick Installation wizard will help you set the most important parameters that are
relevant for your requirements. For security reasons, it is highly recommended to
change the adminstrator password after the camera has been configured
properly.
CAUTION: Make sure that you store information on user names
and passwords in a secure place. In case you loose the
administrator password and cannot access the Admin menu, the
password can only be reset at the factory. This service is not free!

1.4.3 Irreversibly Deactivating the Microphone

Deactivating a camera's microphone may become necessary in order to protect
the privacy of people at a workplace or for other reasons. You can permanently
and irreversibly deactivate the microphone in the Admin Menu > Loudspeaker
and Microphone dialog.
CAUTION: This deactivation is permanent and cannot be reversed
even by MOBOTIX engineers. Deactivating the microphone will
also deactivate all features that use the camera's microphone.

1.4.4 Starting the Camera Using the Factory IP Address

If the camera's IP address is not known any more, you can start the camera with its
factory IP address. Section 3.6, Starting the Camera Using the Factory IP Address ,
describes this procedure in more detail.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com • 31.1.2007