Starting The Camera With The Factory Ip Address - Mobotix M25-Body Manual

104
/136
Passwords and cam-
era settings will
not be changed
Make sure you store
the default network
configuration to the
permanent flash memory
M25M Camera Manual: Operating the Camera

3.2.5 Starting the Camera with the Factory IP Address

Under certain circumstances, you may have to reset the camera to its factory IP address.
This could be the case, for example, if the IP address has been lost or the camera does
not respond to the last known IP address. Proceed as follows to start up the camera with
its factory IP address:
1. If the camera is powered on, disconnect the power supply by unplugging the cor-
responding cables and then reconnect the power supply.
2. Wait until both LEDs light up simultaneously for the first time.
3. Press the L key within the next four seconds and hold it down (if you need to
try again, go back to Step 1). Use a
sharp or pointed objects!
4. After about 30 to 45 seconds, the camera emits a single sound ("boing").
The camera has finished booting and can now be used (e.g., MxEasy, MxControlCenter,
MOBOTIX App, web browser).
If you use the camera's L key to load the factory network configuration, this configu-
ration is not automatically saved in the camera's flash memory. When the camera
is next rebooted without using the L key, the last stored network configuration will
be used. To permanently store the new network configuration in the camera's flash
memory, open Admin Menu > Store.
As opposed to resetting the camera using Admin Menu > Reset configuration to
factory defaults, the user information will not be reset if the camera is booted using
the factory IP address.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
paper clip
for this purpose but
Press "L" key
Notes
www.mobotix.com • sales@mobotix.com
avoid using