Needle Calibration Using The Built In Camera - Brother 882-W20/W22 Operation Manual

NEEDLE CALIBRATION USING THE BUILT IN CAMERA

NEEDLE CALIBRATION USING THE BUILT IN
CAMERA
Setting the camera needle position is essential
when you use camera function. It is not necessary
to perform this operation each time, but we
recommend performing it when the needle is
changed. Use the white stickers (solid) included
with the machine.
a
Hold your finger firmly on the LCD screen,
and then turn on the machine.
Note
• Be careful not to touch the LCD screen prior
b
to Step
• This function can be performed with or
without embroidery unit attached to
machine. If attached, message screens will
appear regarding movement of embroidery
unit.
→ The following screen appears.
+1
+2
+9
78
below.
+4 7+
+5 +8
+3 6+
+11 +13
+10 12+
b
Press the "Automatic Threading" button.
→ Camera needle position setting screen appears.
c
Follow the on-screen instructions to
complete the procedure.
1. Raise needle bar to its highest position.
Note
• The "Needle Position" button cannot be
used while setting the camera needle
position. Turn the handwheel
counterclockwise to move the needle bar.
2. Remove presser foot and replace needle
with a new embroidery needle standard
size 75/11 or 90/14.