Stitch Settings Screen; Line Sew Stitch Settings; Fill Stitch Settings - Brother 882-W20/W22 Operation Manual

STITCH SETTINGS SCREEN

Before creating the embroidery pattern, specify the stitch settings. Lines of the design are sewn with
zigzag stitches, running stitches, or triple stitches, and areas are sewn with fill stitches or stippling stitches.
Stitching of the areas were already selected in "Drawing Regions" on page 343, so specify values of
detailed settings.
If the design data is saved, the settings can be changed after a trial embroidering.
After finished specifying the settings, press

■ Line sew stitch settings

Select the type of the line sew stitch from zigzag stitch (
Zigzag stitch
Zigzag width
Density
Running stitch /Triple stitch
* Both includes an under sewing.
Run Pitch

■ Fill stitch settings

Size
Direction
Density
Pull compensation
Under sewing
to check the preview of the pattern.
Specifies the width of the satin stitches used to sew the lines of the design.
Specifies the density of the satin stitches used to sew the lines of the design.
Specifies the length of the straight stitch of the design.
Increases/reduces the size of the pattern.
Specifies the sewing direction. Set to "Manual" when you have desired direction of fill stitch.
Specifies the stitch density of fill stitch.
Specifies to correct the shrinkage of the pattern by slightly shortening or lengthening the
stitching. Change the setting after once you embroider the pattern and check the shrinkage.
Select if you need or not need the under sewing stabilize fabric.

STITCH SETTINGS SCREEN

), running stitch ( ) or triple stitch ( ).
8
347