Brother 882-W20/W22 Operation Manual page 277

b
Lower the presser foot, then press the
"Start/Stop" button to start embroidering.
→ When the first color is completely sewn, the machine
will automatically trim the threads and stop. The
presser foot will then automatically be raised.
On the embroidery color order display, the next
color will move to the top.
Memo
• If you want to get more attractive finishes,
try the procedures below;
- After 5-6 stitches, press the "Start/Stop"
button again to stop the machine.
- Trim the excess thread at the end of the
seam. If the end of the seam is under the
presser foot, raise the presser foot, then
trim the excess thread.
• If there is thread left over from the beginning
of sewing, it may be sewn over as you
continue embroidering the pattern, making
it very difficult to deal with the thread after
the pattern is finished. Trim the threads at
the beginning of each thread change.
c
Remove the thread for the first color from
the machine. Thread the machine with the
next color.
EMBROIDERING AN PATTERN
d
Repeat the same steps for embroidering the
remaining colors.
a
b
c
a Current stitch numbers/Total stitch numbers
b Current time/Total time
c The part of pattern embroider next
d Embroidered colors/Total colors
→ When the last color is sewn, "Finished
embroidering" will appear on the display. Press
, and the display will return to the original
screen.
Memo
• The Thread Trimming Function is originally
set to trim excess thread jumps (threads
linking parts of the pattern, etc.). Depending
on the type of thread and fabric that are
used, an end of upper thread may remain
on the surface of the fabric at the beginning
of the stitching. After embroidering is
finished, cut off this excess thread.
If the setting has been turned off, trim the
excess thread jumps using scissors after
the pattern is finished.
See page 304 for information on the thread
trimming function.
d
6
275