Brother 882-W20/W22 Operation Manual page 400

ERROR MESSAGES
398
This message is displayed
when the machine failed to
recognize the embroidery
positioning mark.
- Confirm that the
embroidery positioning
mark is in the selected
area. If problem persists,
see page 268 to
reposition mark.
- Machine failed to
recognize printed
positioning mark. Set
"Page Scaling" to "None
(100%)", and try printing
the embroidery
positioning mark again.
(see page 299)
This message is displayed
when the machine has
recognized the embroidery
position mark. Remove the
embroidery positioning
sticker and press
to continue. To remove the
embroidery positioning
sticker more easily, press
. (see page 268)
This message appears
when the built-in camera is
being used to align the
embroidery position, but
the embroidery positioning
sticker is too near an edge
or the pattern extends from
the embroidery frame.
Change the positioning of
the embroidery position
sticker, and then try
aligning the position again.
See page 263.
This message is displayed
when the upper thread is
broken or not threaded
correctly, and the "Start/
Stop" button or the
"Reverse/ Reinforcement
Stitch" button is pressed.
This message is displayed
when the "Presser Foot
Lifter" button is pushed
while the presser foot lever
is raised/the needle is
lowered.
This message is displayed
when the "Start/Stop"
button is pushed to sew
Utility stitches or
Character/Decorative
stitches while the foot
controller is connected.
(This message does not
appear when
embroidering).
This message is displayed
when the "Start/ Stop"
button is pushed while the
machine is in embroidery
edit mode and a pattern is
being edited.
This message is displayed
when there is no stitch or
embroidery pattern
selected and the "Start/
Stop" button or the
"Reverse/Reinforcement
Stitch" button is pressed.
This message is displayed
when the bobbin thread is
running out.
This message is displayed
when the memory is full
and the stitch or pattern
cannot be saved.
This message is displayed
when, after selecting a
pattern, ,
, or is
pressed and the pattern is
about to be deleted.
This message is displayed
when the bobbin is being
wound, and the motor
locks because the thread is
tangled, etc.
This message is displayed
when there is a possibility
that the data for the
selected pattern is
corrupted.