Care And Maintenance; Restrictions On Oiling; Precautions On Storing The Machine; Cleaning The Lcd Screen - Brother 882-W20/W22 Operation Manual

CARE AND MAINTENANCE

CARE AND MAINTENANCE

• Be sure to unplug the machine before cleaning it. Otherwise, electric shock or injury may result.

Restrictions on oiling

In order to prevent damaging this machine, it must
not be oiled by the user. This machine was
manufactured with the necessary amount of oil
applied to ensure correct operation, making
periodic oiling unnecessary.
If problems occur, such as difficulty turning the
handwheel or an unusual noise, immediately stop
using the machine, and contact your authorized
Brother dealer or the nearest Brother authorized
service center.
Precautions on storing the
machine
Do not store the machine in any of the locations
described below, otherwise damage to the
machine may result, for example, rust caused by
condensation.
* Exposed to extremely high temperatures
* Exposed to extremely low temperatures
* Exposed to extreme temperature changes
* Exposed to high humidity or steam
* Near a flame, heater or air conditioner
* Outdoors or exposed to direct sunlight
* Exposed to extremely dusty or oily environments
Note
• In order to extend the life of this machine,
periodically turn it on and use it. Storing this
machine for an extended period of time
without using it may reduce its efficiency.

Cleaning the LCD Screen

If the screen is dirty, gently wipe it with the
included LCD cleaning cloth or a soft, dry cloth.
Do not use organic solvents or detergents.
Note
• Do not wipe the LCD screen with a damp
cloth.
378
CAUTION
Memo
• Occasionally, condensation may form on
the LCD screen or it may become fogged
up; however, this is not a malfunction. After
a while, the cloudiness will disappear.

Cleaning the Machine Casing

If the surface of the machine is dirty, lightly soak a
cloth in a neutral detergent, squeeze it out firmly,
and then wipe the surface. Then wipe again with a
dry cloth.

Cleaning the Race

a
Press the "Needle Position" button to raise
the needle.
b
Turn the main power to OFF.
c
Remove the needle and the presser foot
holder (see pages 71 through 75).
d
Remove the flat bed attachment or the
embroidery unit if either is attached.
e
Grasp both sides of the needle plate cover,
and then slide it toward you.
a Needle plate cover
→ The needle plate cover is removed.