Brother 882-W20/W22 Operation Manual page 326

USING THE CAMERA TO CONNECT PATTERNS
n
Affix the first embroidery positioning
sticker onto the fabric within the red lines
that now appear on the screen of the
machine by using both hands to press down
on each corner of the sticker. Affix the
sticker with the large circle to the top as
shown on machine. Then, press
→ The camera detects the first positioning sticker.
Note
• Use new positioning stickers. If a sticker is
reused, it may easily peel off. If the sticker
peels off during this procedure, the patterns
cannot be connected.
• Using fingers apply pressure to the corners
of the positioning sticker to firmly affix it to
the fabric. If the sticker is not firmly
attached, the camera may incorrectly detect
the sticker.
• If any of the following messages appear,
reattach the positioning sticker in the
correct position. Make sure that the sticker
is affixed with the large circle at the top.
324
o
Using both hands affix the second
embroidery positioning mark within the red
lines that now appear on the screen of the
machine by pressing down on each corner
of the positioning mark onto the material
and then touch
.
→ The camera detects the second positioning sticker.
p
After the two positioning stickers have been
detected, the following message appears.
a Embroidering area
.
a