Brother 882-W20/W22 Operation Manual page 70

UPPER THREADING
• When using thread on a thin spool, place the
included spool felt on the spool pin, place the
thread spool on the spool pin so that the center
of the spool is aligned with the hole at the center
of the spool felt, and then insert the spool cap
onto the spool pin.
a Spool felt
• When using thread on a cone spool, use the
spool holder. When using cone shaped thread
spool with other than cotton thread, it is not
necessary to use spool caps.
a Spool holder
• Depending on the size of spool or the amount of
thread remaining, choose the appropriate sized
spool cap (large or medium). Spool cap (small)
cannot be used with the spool cap base.
a Spool cap
b Spool cap base
68
a
Attach the spool stand to the machine. (see
page 24.)
b
Place the spool of thread on the spool pin
so that the thread feeds off the spool
clockwise. Firmly insert the spool cap onto
the spool pin.
Note
• When using 2 spools of thread, make sure
that both spools are feeding in the same
direction.
• Make sure that the spools do not touch
each other, otherwise the thread will not
feed off smoothly, the needle may break, or
the thread may break or become tangled. In
addition, make sure that the spools do not
touch the telescopic thread guide at the
center.
• Make sure that the thread is not caught
under the spool.