Brother 882-W20/W22 Operation Manual page 398

ERROR MESSAGES
396
This message appears
when there are not enough
colors in the thread table,
to display the color scheme
effect you have selected.
In this case, select another
effect or the custom thread
table (300 color palette) or
less colors in the color
shuffling function. (See
page 241.)
If there are not enough
number of colors set in the
custom thread table, set
more colors in the table.
(See page 237.)
This message is displayed
when the automatic needle
threading button is pushed
while twin needle sewing is
set.
This message is displayed
when the "Start/Stop"
button is pressed before
the edge of the fabric is
detected. To detect the
edge of the fabric using the
built-in camera, press
, raise the presser
foot, and then perform the
operation again. (see page
162)
This message is displayed
when the built-in camera
cannot detect the edge of
the fabric.
If this message appeared
after sewing has reached 1
to 2 cm (about 3/8 to 3/4
inch) from the edge of the
m
fabric, refer to step in
"Edge Sewing" on
page 167.
If this message appeared
during edge sewing, the
edge of the fabric cannot
be detected by the built-in
camera. Press ,
raise the presser foot, raise
the needle if it is lowered,
and then perform the
procedure described in
"Edge Sewing" on
page 164 starting from step
f
.
If this error message
appears again, sew without
using edge sewing
function.
This message appears
when you try to save more
than 100 camera image or
settings screen image files
in the USB media. In this
case, delete a file from the
USB media or use different
USB media. (See page 36
and 98)
This message appears
when or is
pressed to delete the
settings for a utility stitch.
To delete the selected
settings, press .
This message is displayed
when an unusable
embroidery card is
inserted.
This message is displayed
when the "Reverse/
Reinforcement Stitch"
button is pushed while the
embroidery unit is
attached.
This message is displayed
when the foot controller is
pressed while the
embroidery unit is attached
and machine is set up for
embroidering.
This message is displayed
when the patterns you are
editing take up too much
memory, or if you are
editing too many patterns
for the memory.
This message is displayed
when a key on the LCD
display is touched while the
needle is in the down
position.
This message is displayed
when there are too many
characters and the curved
character configuration is
impossible.
This message is displayed
when the machine is in
embroidery mode, and the
character pattern
combination is too large to
fit in the embroidery frame.