Installing The Front Bezel; Removing And Installing The System Cover; Removing The System Cover; Figure 14. Installing The Front Bezel - Silicon Graphics Altix XE210 User Manual

Installing the Front Bezel

Use the following steps.
1. At each end of the bezel, line up the center notch on the bezel with the center guide
on the rack handles.
2. Push the bezel onto the front of the server system until it clicks into place.
3. Connect any necessary cables to the front control panel area at the right side of the
server system.

Removing and Installing the System Cover

Removing the System Cover

The server system must be operated with the system cover in place to ensure proper
cooling. You will need to remove the top cover to add or replace components inside of the
server. Before removing the chassis cover, power down the server and unplug all
peripheral devices and the AC power cable(s).
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Turn off all peripheral devices connected to the server. Turn off the server.
® ®
SGI Altix XE210 User's Guide

Figure 14. Installing the Front Bezel

TP02200
"Safety
21