Installing And Removing Memory; Installing Dimms; Figure 19. Installing The Processor Air Duct - Silicon Graphics Altix XE210 User Manual

Installing and Removing Memory

The silkscreen on the board for the DIMMs displays DIMM A1, DIMM A2, DIMM B1,
DIMM B2, DIMM C1, DIMM C2, DIMM D1 and DIMM D2 starting from the center of
the board. Contact your SGI representative for qualified memory components.

Installing DIMMs

To install DIMMs, follow these steps:
1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord(s) from the server.
4. Remove the server's cover. See
instructions on removing the server's cover.
5. Locate the DIMM sockets (see
26

Figure 19. Installing the Processor Air Duct

"Removing and Installing the System Cover"
Figure
"Safety Information".
20).
®
SGI Altix
TP02202
for
®
XE210 User's Guide