Installing The Pci Riser Assembly; Figure 36. Installing Pci Riser Assembly Into The Server System - Silicon Graphics Altix XE210 User Manual

Installing the PCI Riser Assembly

1. Lower the riser assembly into place (see letter "A").
2. Align the four hooks in the riser assembly with the matching slots at the back of the
server system (see letter "B").

Figure 36. Installing PCI Riser Assembly into the Server System

3. Press down uniformly until the four hooks on the rear of the PCI riser assembly
engage the server system back panel slots. The riser cards will seat into the
matching sockets on the server board.
4. Lock the retention clip as shown in the figure (see letter "C").
5. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
6. Re-install the processor air duct. For instructions, see
Duct".
7. Install the server system cover. For instructions, see
8. Install the front bezel. For instructions, see
9. Plug all peripheral devices and the AC power cable(s) into the server.
® ®
SGI Altix XE210 User's Guide
A
B
"Installing the Front
C
AF000363
"Installing the Processor Air
"Installing the System
Bezel".
Cover".
43