Removing The Rack Handles; Figure 57. Removing The Rack Handle - Silicon Graphics Altix XE210 User Manual

Removing the Rack Handles

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel. For instructions, see
4. Remove the server system cover. For instructions, see
Cover".
5. Remove the two screws holding the rack handle in place, and remove the rack
handle from the server system as shown in the figure below.
6. Install the server system cover. For instructions, see
7. Plug all peripheral devices and the AC power cable(s) into the server.
® ®
SGI Altix XE210 User's Guide

Figure 57. Removing the Rack Handle

"Removing the Front
"Removing the System
AF000378
"Installing the System
"Safety
Bezel".
Cover".
67