Microscan MINI Hawk User Manual page 348

Serial Configuration Commands
Serial Command Format
Serial commands are of two types: utility and configuration.
Rules that apply to both utility and configuration commands
• A less than < and greater than
• Commands and data are "case sensitive." That is, characters must be entered as upper
or lower case, as specified.
Serial Utility Commands
These are sent during operations and are not followed by
Serial Configuration "K" Commands
These begin with a single "K" character followed by a 3-digit numeric character, data
fields, and an initializing command, as follows:
<Knumeric parameter,data,data,...etc.><initializing command>
An initializing command
imager's memory and saves for power-on; an
does not save for power-on.
For example, to enable UPC and save the change for power-on, send <K473,1><Z>.
To change Baud Rate and reset without saving changes for power-on, send
<K100,3><A>.
Serial Configuration Command Conventions
• All data fields (except the last) must be followed by a comma (without a space).
• NUL cannot be used. The characters <, >, and
pairs (see ASCII Character Entry Modifier
• All fields preceding a modified field must be included.
• If there is no change in preceding fields, then commas alone can be entered in these
fields. For example, if only the last field in the following command is changing,
<K100,4,1,0,0>
• All fields following a modified field can be omitted. For example, to change Baud Rate
only, send <K100,3>.
A-12
> character enclose the commands.
<A> or <Z> may follow the command. A
can be entered as <K100,,,,0>.
<A> or <Z>.
<A> initializes the imager's memory but
,
can be used, but only if entered as hex
on page 3-32).
MINI Hawk High Performance Imager User's Manual
<Z> initializes the