IRC Test
1. Select IRC from the
H/W TEST MENU to
display the IRC
TEST menu.
2. Select "1. Register
# Setting" to enter the
IRC register number
(1-32).
Select 2 - 5 for a
specific test. Refer
to the table below for
an explanation of
each test.
3. Press any key to end
the test and return to
the IRC TEST menu.
#
2
3
4
5
SER-7000 Program Manual
1 .
2 .
3 .
4 .
5 .
TEST
INTERNAL LOOPBACK
(CHIP)
INTERNAL LOOKBACK
(DRIVER)"
EXTERNAL LOOPBACK
IRC SYSTEM TEST
I R C T E S T
R E G I S T E R # S E T T I N G
I N T E R N A L L O O P B A C K ( C H I P )
I N T E R N A L L O O P B A C K ( D R I V E R )
E X T E R N A L L O O P B A C K
I R C S Y S T E M T E S T
Notes
Tests the internal IRC integrated circuit. Test
runs continuously counting success (S) and failure
(F).
Tests the internal IRC driver. Test runs
continuously counting success (S) and failure (F).
This test requires a loopback connector. Test
runs continuously counting success (S) and failure
(F).
Test sends packet to each register in the range
input. Test runs continuously counting success
(S) and failure (F).
S-Mode Programming
27