Sam4s SER-7000 Manual page 126

Validation/Subtotal Print Options Program Notes
NOTE: To validate, you must attach a printer with validation capability to each
register that will validate. Use option #7 to identify the port to which the printer is
attached.
#
1
2
3
4
5
6
7
8
120 P-Mode Programming
FIELD
VALIDATION AMT:
Y=TOTAL/N=TENDER
CHK VALID AMT:
Y=TTL/N=TEND
ACTIVATE VALIDATION
SENSOR
ALLOW MULTIPLE
VALIDATIONS
PRINT VALIDATION
MESSAGE
PRINT SBTL WHEN SBTL
PRESSED
VALIDATION PORT# (0-4)
DISPLAY RUNNING SUBTL
ON POLE
Notes
For sale validation, you can select either the
amount of the sale or the amount of the tender
as the amount to print on the validation.
For check sale validation, you can select
either the amount of the sale or the amount of
the tender as the amount to print on the
validation.
The printer must be equipped with validation
option and sensor.
If Y, the validation can be done more than
once.
See "Validation Message" on page 57 to
program a message of up to three lines.
If Y, the receipt (if applicable) will print the
subtotal at the point in the transaction when
the key was pressed.
Indicate the port on the register that is
connected to the validation printer.
Allows the pole display to show a running
subtotal as items are entered.
SER-7000 Program Manual