Running [No Stamp] Mail; How To Process Mail Without Printing (Settings) - Hasler IM-440 User Manual

DELTA2_US.book Page 49 Samedi, 5. avril 2008 3:50 15

Running [No Stamp] Mail

3.5

Running [No Stamp] Mail

This section describes the parameter settings and mail handling sequence for mail
processes that use the [No Stamp] type of stamp, to:
Seal envelopes, using the auto-feeder (if installed)
•
Only convey mail, for counting or testing purposes.
•
See also
• To choose the type of stamp to use for each type of mail process, see Choosing a
Type of Stamp p.25).
Sequence of Settings
The procedure below outlines steps in a recommended sequence to process mail.
You must begin with selecting the Type of stamp to gain access to the corresponding
parameters and be able to run mail.
Make sure you have completed the preparation steps mentioned
in Preparing and Starting your Work Session p.27.

How to Process Mail without Printing (Settings)

How to Process
Main setting:
1
Mail without
Printing
(Settings)
2
To select an option in the screen:
Make sure you are on the home screen of the [No stamp]
type of stamp.
The type of stamp is indicated at the top of the home screen
as illustrated.
Check or change the type of stamp:
Press to access the Build stamp/imprint screen:
Highlight the option using the arrow keys
Then always press
To change the type of stamp, select the Type line, press
[OK] and then select [No stamp] in the Type of stamp screen
and press [OK].
No other parameter is required to run mail in this mode.
Press or
and
to validate your selection.
to return to the home screen.
3
49