Filling And Adjusting The Feeder Sealer; How To Fill The Sealer Bottle; How To Adjust The Sealing Water Flow - Hasler IM-440 User Manual

DELTA2_US.book Page 169 Samedi, 5. avril 2008 3:50 15

Filling and Adjusting the Feeder Sealer

10.2 Filling and Adjusting the Feeder
Sealer
Filling the Sealer Bottle
The automatic feeder uses water for sealing envelopes.
If the system is out of water, the mailing process continues but the envelopes are not
sealed properly.

How to Fill the Sealer Bottle

How to Fill the
To add water to the bottle:
Sealer Bottle
1
2
3
Adjusting the Sealing Water Flow
Before you adjust the sealing water flow, make sure that the brushes and sponge are
clean (see How to Clean the Brushes and Sponge (Sealer) p.172).

How to Adjust the Sealing Water Flow

How to Adjust
To adjust the sealing water flow:
the Sealing
1
Water Flow
Remove the bottle from
its base and turn it over.
Unscrew the cap and fill
the bottle with water up
to the limit marks.
Screw the cap back and
put the bottle back into
place.
Set the water flow using
the back lever.
When standing in front of
the Feeder:
Push the lever
towards the left-hand
side to increase the
water level.
Push the lever
towards the right-hand side to decrease the water level.
10
169