IBM Professional Series User Manual page 34

yet been told to insert any of the three diskettes into a
diskette drive. The screen was shown to prepare you to
properly respond to future prompts from the DOS
RESTORE command. The RESTORE command will
soon be used to create a single file on your C disk from
data previously stored (using the DOS BACKUP
command) on the three VM/PC Distribution Diskettes
4,5, and 6.
NOTE:
You may wish to read the description of the
RESTORE command in the DOS manual before
continuing.
After locating ALL THREE diskettes, go to STEP 9.
STEP 9. Press ENTER.
After you press ENTER, the installation program
invokes the RESTORE command. Then you will see:
Insert backup diskette 01 in drive A:
Strike any key when ready
When you see the above prompt, insert VM/PC
Distribution Diskette 4 in drive A and go to STEP 10.
STEP 10. Press any key.
NOTE:
When we say "any key," we mean "any key or
combination of keys that generates a character."
This meaning is used consistently by DOS.
After moving the data on the diskette in drive A to the C
disk, the RESTORE command prompts you for the next
distribution diskette. You will see:
Chapter 2. Installing VM/PC 2-11