IBM Professional Series User Manual page 324

NO USER DEFINITIONS IN CONFIGURATION FILE;
RUN CONFIGURATOR (DMKOI7T)
The control program found no user information in the
configuration file. Run the configurator to define the
user(s) of the system.
o
OPERAND MISSING OR INVALID (DMK026E)
You did not enter a required operand or entered it
incorrectly.
OS simulation is not available (DMS098S)
An OS SVC was issued, and the CMS OS simulation
support was not available at that time. Issue the
command SET OSSIM ON, and re-issue the command.
P
PAGING I/O ERROR ON CP NUCLEUS (DMKOI9T)
The control program had an irrecoverable data error
while reading the control program nucleus file. Restore
the nucleus file from VM/PC installation diskette 2.
R
Ready; (DMS)
This is the CMS prompt, and tells you that CMS is
waiting for a command. It may also appear as
Ready(rc); where rc is the return code of the previous
command you entered.
Remote disk mode (cuu) released (DMS802E)
The communication with the remote server has been
stopped or restarted. The remote minidisks which you
had accessed are released automatically. To re-establish
the connection to remote minidisks you should restart the
remote server· if it is not running, and issue the
appropriate LINK and ACCESS commands to establish
the connection to the remote minidisks again.
Chapter 8. VM/PC Messages 8-21