IBM Professional Series User Manual page 316

Error in fn ft fm, line nnn - message (DMS085E)
The EXEC2 interpreter has found an error in the
specified file, at line "nnn." Correct the EXEC file based
on the text of the error message, and re-issue the
command.
Error occurred when allocating a service (SERV)
You should retry VMPCSERV and contact your
technical co-ordinator if the program continues to fail.
Error occurred when trying setup/remove I/O interrupt
handler, return code: nnn (SERV)
You should retry VMPCSERV and contact your
technical co-ordinator if the program continues to fail.
Error occurred when trying to define a service (SERV)
You should retry VMPCSERV and contact your
technical co-ordinator if the program continues to fail.
ERROR READING CP MESSAGE FILE (DMK016T)
The control program had an irrecoverable data error
while reading the control program message file. Restore
the message file from VM/PC installation diskette 2.
ERROR READING VM/PC CONFIGURATION FILE
(DMK013T)
The control program had an irrecoverable data error
while reading the configuration file. Run the
configurator to correct any data problems.
Error when trying to display the logo (SERV)
You should retry VMPCSERV and contact your
technical co-ordinator if the program continues to fail.
Execution begins... (DMS7401)
You have requested the execution of a program under
CMS.
Export terminated, insufficient disk space available
(DMS806E)
The EXPORT of the file failed because there was no
space left on the drive to create the PC file. You should
make enough space available on the drive to create the
file, and retry the operation.
Chapter 8. VM/PC Messages 8-13