IBM Professional Series User Manual page 154

CP TERMINAL HILIGHT OFF (if your system
supports the HILIGHT option of the TERMINAL
command)
SET AUTOREAD ON
SET BLIP OFF
SET IMP EX OFF (if you have an exec called EDIT
on your system which would invoke an editor other
than the CMS EDIT editor.)
Note: You will probably want to restore the SET and
TERMINAL characteristics following this installation
procedure.
Step 4 - Now return to the Session Selection Menu (by
pressing the Select key) and select the Local 3277
Session.
• Step 5 - Insert installation diskette 3 in drive A, and
logon to your local session using a userid of CMS, a
password of CMS (if the default password has not been
changed), and an Environment of CMS. Diskette 3
contains the CMS 101 minidisk where the VMPCSERV
installation is found. You will receive a message when
the Remote Services program mini disk is automatically
accessed, asking if you wish to continue with the
installation. If you choose to continue, the files needed
to create a Remote Server program (the exec and texts)
are uploaded to your remote VM system.
The installation is performed in three parts. You will be
prompted on the local session before the start of each
part, where you may decide to perform the part, skip the
part, or stop the installation of the remote server. You
should only skip the part if you are re-starting the
installation, and are certain that this part has previously
been completed successfully.
While each part of the remote server installation is being
done, you should select the remote session as your active
session, and observe the installation procedure for
correct functioning.
If
the message "NOT ACCEPTED"
Chapter 6. Remote Services 6-5